Progress of an excellent coating Cleaning the surface from oils, dusts and all kinds dirt before the coating. Sand blasting in order to make coating stronger ( 40-120 mesh ) by aluminum oxide. Surface cleaning after sand blasting. Coating progress by spray line, electrostatic or dipping depends on the products. Coated products get cure after every single layer coating. Tests and measurements on the final coated surfaces , and recording results.
The most important point in order to reach to the target coating quality and solution is full information from customer about the surface working condition.
The reason of coating ? (Anti-Corrosion, Non-Stickness, etc )
Chemicals in the area of working ?
Air conditions in the area of working ?
Materials in contact with the coated surface ? (textile ,paper, etc)
The type of material and the thickness of surface